HOME PAGE

Should the bevel gear pair not have any axial shift, then the coefficient C is 1, as per Figure17-7. The tooth profile factor, YF, per Equation (17-31) is simply the YFO This value is from Figure 17-8 or 17-9, depending upon whether it is a straight or spiral bevel gear pair. The graph entry parameter values are per Equation (17-32).     YF = YFO                                 (17-31)                   (17-32) where: ha = Addendum at outer end (mm)           hao = Addendum of standard form (mm)            m = Radial module (mm)    The axial shift factor, K, is computed from the formula:

(17-33) 17.3.3.C Load Distribution Factor, Ye     Load distribution factor is the reciprocal of radial contact ratio.    Ye =   1                                            (17-34)             ea           The radial contact ratio for a straight bevel gear mesh is: (17-35)

413